Stringy layers between support and object

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
User avatar
Posts: 172
Joined: Mon Jun 12, 2017 5:10 am

Stringy layers between support and object

Postby jetdillo » Sun Sep 30, 2018 4:24 pm

I'm seeing a really stringy first layer being layed down overtop some support needed to support an overhang.
I don't recall seeing this on other parts I've printed where there was "ledge" or "shelf" of support material supporting a significant overhang.
What do you guys think ?

This is with PETG being fed from a PrintDry.
0.2mm layer height.
245C nozzle temp.
75C bed
20% part infill
20% infill for support , using Lines as the support method.
vertical offset top layers: 1
vertical offset down layers: 1
40 mm/sec all around speeds.

Posts: 386
Joined: Thu Jul 12, 2018 8:34 pm

Re: Stringy layers between support and object

Postby Shelton » Mon Oct 01, 2018 2:23 pm

Extruder retraction enabled?

Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 2 guests