Z-Axis to offset or to not offset

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
Posts: 4
Joined: Tue May 30, 2023 8:03 pm

Z-Axis to offset or to not offset

Postby BensDad » Wed May 31, 2023 10:41 am

When leveling my bed, the Ender 3 Pro instructions indicate the nozzle should be an A4 paper width from the bed at the Z-axis, the some as the 4 corners. However, several sites (YouTube) insist the nozzle should just touch the bed irrespective of the four corners have an A4 space

Which is it?

TIA folks

Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 1 guest