Help me with a standard PLA Print

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
Posts: 1
Joined: Mon Jun 07, 2021 8:09 am

Help me with a standard PLA Print

Postby henning.manke » Wed May 25, 2022 6:51 am

Hi all,

This is my first post here, so please excuse any mistakes from my side and feel free to move this post to another category, if not chosen accordingly.

I am currently printing the attached Cable Holder with the Raise3D PLA (black). I just used the standard highest quality settings for this filament on a Raise3D Pro2. Previous prints with other colours were quite successful, but this one turned out really bad. There is a lot of stringing and one of the two sides of the spiral gets printed with lots of bulk.

I hope you can help me with this one, as I'm quite new to printing anyhow.

Best Regards,
(2.74 MiB) Downloaded 35 times

Posts: 64
Joined: Fri Apr 16, 2021 12:35 pm

Re: Help me with a standard PLA Print

Postby MBellahcene » Fri Jun 10, 2022 12:50 am


If the other colours were with the same PLA it may be the nozzle that gets old or the filament that gets bad after a while openned.
Lets retry with other colours again.
If you got stringing with the other that worked it's certainly the nozzle.

User avatar
Posts: 475
Joined: Thu Oct 28, 2021 10:43 pm

Re: Help me with a standard PLA Print

Postby Ryan@Raise3D » Tue Jun 14, 2022 12:39 am

different colors of materials can sometimes have different properties due to the dye used for each color so it is possible you may need to reduce the temperature of the material for your print.

Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 2 guests