Request for advice on setting up slicing

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
mich0111
Posts: 1
Joined: Fri Jan 21, 2022 7:12 pm

Request for advice on setting up slicing

Postby mich0111 » Fri Jan 21, 2022 7:31 pm

Hi,
I have used your great software, Iterator, to help me to define the right setting of my profile.
I think it is almost correct... except the Top Surface Test. I suppose I don't understand your indications.
So, could you please indicate to me what could be the fixes to get a perfect profile for my printer?
Thank in advance for your help
Best regards
Michel
Attachments
Top Surface Test 1.jpg
Top Surface Test 2.jpg
Top Surface Test 3.jpg

User avatar
Ryan@Raise3D
Posts: 415
Joined: Thu Oct 28, 2021 10:43 pm

Re: Request for advice on setting up slicing

Postby Ryan@Raise3D » Fri Jan 28, 2022 1:24 am

Based on the top surface what may be happening here is either the solid fill flow rate is too high or your infill overlap setting is not high enough causing the lines to not merge properly.


Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 2 guests