Cant Seem to get a good print anymore

Share your successful printing settings with others here. If you have any question about the parameters or printing skills of some filament, please find here.
javed
Posts: 1
Joined: Wed May 20, 2020 4:15 pm

Cant Seem to get a good print anymore

Postby javed » Thu May 21, 2020 1:24 pm

Hello,

So, I've never had any issues with my Raise3D pro2, printing both PLA and ABS with no complaints.

Recently, due to the response to COVID-19 I attempted to print the AirAngel to assist some doctors with intubating patients. During this print the material got stuck in the extruder. I had to take down the hotend to clear it. Since i have done this however, I cannot seem to get the printer to complete good prints.

I believe it is something I may be doing incorrectly with calibrating the machine. I am not sure. Any help would be greatly appreciated. I have attached an image my latest attempt to print a door lock.

Settings:
Bed temp: 100
Nozzle temp: 250
Material: Rasie3D Premium ABS

door lock.jpg

doorlock.jpeg

User avatar
Vicky@Raise3D
Posts: 6464
Joined: Fri Mar 25, 2016 3:54 am

Re: Cant Seem to get a good print anymore

Postby Vicky@Raise3D » Sat May 23, 2020 1:10 am

It seems like there may be a partial clog inside the nozzle or something not allowing the filament to flow properly. Can you try run the ABS through loading sequence to see if there are any issues with the flow of the material.


Return to “Printing Settings”

Who is online

Users browsing this forum: No registered users and 1 guest