Page 1 of 1

Fault Codes added to Manual

Posted: Wed Jul 17, 2019 4:12 pm
by MMER1116
The new repair/service manual is well written and easy to follow for all printer service. Can a list of the touch screen fault codes with a failure description be included?

This is my last error,

Board Error. Error Sensor: T1
Please Check Hardware & Restart
Please Go To "Temp Task" to continue this task

I did the "Restart" as prompted, the selected continue the print, which it did. This has occurred (3) times over the past two days. It would be helpful to know what hardware to check. Also, what is the "Temp Task"? I never saw this option on the Touch Screen.

Re: Fault Codes added to Manual

Posted: Wed Jul 17, 2019 11:37 pm
by Vicky@Raise3D
The T1 error incates a temperature sensor. Which means the motion board has got some weird temperature value it thinks that should be detected at this moment. Normally it is a hardware issue related to thermocoupler, extruder board and some related cable.
Temp Task is normally saved during a power loss to give you chance to recover the stopped prints due to power loss. It is a tab in the Print tab with Uploading Queue and Dashboard.