Fault Codes added to Manual

Any topics that don't fall into above categories. Please note that your thread may be moved to other discussion boards.
MMER1116
Posts: 8
Joined: Mon Jul 02, 2018 1:11 am

Fault Codes added to Manual

Postby MMER1116 » Wed Jul 17, 2019 4:12 pm

The new repair/service manual is well written and easy to follow for all printer service. Can a list of the touch screen fault codes with a failure description be included?

This is my last error,

Board Error. Error Sensor: T1
Please Check Hardware & Restart
Please Go To "Temp Task" to continue this task

I did the "Restart" as prompted, the selected continue the print, which it did. This has occurred (3) times over the past two days. It would be helpful to know what hardware to check. Also, what is the "Temp Task"? I never saw this option on the Touch Screen.

User avatar
Vicky@Raise3D
Posts: 5456
Joined: Fri Mar 25, 2016 3:54 am

Re: Fault Codes added to Manual

Postby Vicky@Raise3D » Wed Jul 17, 2019 11:37 pm

The T1 error incates a temperature sensor. Which means the motion board has got some weird temperature value it thinks that should be detected at this moment. Normally it is a hardware issue related to thermocoupler, extruder board and some related cable.
Temp Task is normally saved during a power loss to give you chance to recover the stopped prints due to power loss. It is a tab in the Print tab with Uploading Queue and Dashboard.


Return to “Others”

Who is online

Users browsing this forum: No registered users and 1 guest