Raise3D is always listening. If you have a feature requested related to our product, or if you have new ideas that need attention from the community, please post here.
11 posts • Page 1 of 1
This is an important feature, present in many other slicers including Zortrax and Up. Multiple, pre-programmed pause points for filament changes, embedding things in prints, etc.
walshlg wrote:OK I've not really burrowed into gcode, not being lazy, how do you put in a pause until button push and detect button push in gcode?
Not sure what you're getting at. The printer already has a manual pause button on the LCD UI. What we're talking about is the ability to embed precise pause positions at slice time so the printer stops automatically during printing and waits for you to do whatever you need to do, then resumes when you tell it to.
Who is online
Users browsing this forum: No registered users and 1 guest