Page 1 of 1

Bed to front when pausing print

Posted: Wed Mar 17, 2021 4:22 pm
by kurtzr
Hi all,

Is there any way to get the print bed to idle at the front of the enclosure rather than tucked away in the back when an active print is paused. Usually I pause things in order to address some issue with the print. It really doesn't make any sense to have the build plate position itself in the most inaccessible area.

Thanks!

Re: Bed to front when pausing print

Posted: Mon Mar 29, 2021 9:51 am
by Bikeracer
Plus 1 on that suggestion.

Re: Bed to front when pausing print

Posted: Tue Mar 30, 2021 5:15 am
by Vicky@Raise3D
We will take your suggestions and add moving axes during pause into developing list for future versions.
Thanks for your support!

Re: Bed to front when pausing print

Posted: Wed Jan 12, 2022 5:39 pm
by ribo10
This still has not been addressed and to be clear it is a fix not a preference. It NEVER should have been put to the back. FIX IT.

Re: Bed to front when pausing print

Posted: Fri Jan 14, 2022 1:16 am
by Ryan@Raise3D
I am sorry that it has not been addressed as of yet, but our development team is aware of this and it should be addressed in a future version of the firmware.