Raise3D is always hearing. If you have a feature requested related to our product, or if you have new ideas that need attention from the community, please post here.
11 posts • Page 1 of 1
The printer is using Touchscreen to collect the printer status and codes from print files to motion board. You may need to upload the file to touchscreen first then touchscreen can read the codes to start printing.
Noren wrote:kubo10 wrote:So I can´t connect to my network drive with .gcode files ?
I think you can SSH into the printer though.
Yes, but printer read .gcodes only from /home/root ? Someway to change it in config or something like that ?
Who is online
Users browsing this forum: No registered users and 2 guests