Page 1 of 1

Ideamaker: Layer warning

Posted: Mon Dec 17, 2018 10:58 am
by Korni
Hello,

it would be nice if there would be a layer warning in Ideamaker, with which you can set from/at a certain layer comes a hint ...
Use: With critical layer changes you can go to the printer and observe it.

Re: Ideamaker: Layer warning

Posted: Tue Dec 18, 2018 1:16 am
by Vicky@Raise3D
Do you mean that you want the touchscreen pop out a warning when print reaches to some layer you choose? And the warning are defined by yourself?
Do you want the print pause together?

Re: Ideamaker: Layer warning

Posted: Tue Dec 18, 2018 6:35 am
by Korni
Touchscreen or rather in Ideamaker. Warning is not the right word, rather message when reaching a certain layer. At the same time a print pause does not have to be, a message is enough.

Re: Ideamaker: Layer warning

Posted: Tue Dec 18, 2018 10:15 pm
by Vicky@Raise3D
Do you want to define the text in message yourself or not?

Re: Ideamaker: Layer warning

Posted: Wed Dec 19, 2018 6:40 am
by Korni
An individual notification text would be nice but not absolutely necessary. More important would be the correct warning time, depending on the print speed/print area.

Re: Ideamaker: Layer warning

Posted: Thu Dec 20, 2018 11:56 pm
by Vicky@Raise3D
So you only want the printer send you a notification via Text Message, Email through phone App, touchscreen or RaiseCloud to notify you that the print reaches to the point you are looking for. And the print will still continue as nothing happens?

Re: Ideamaker: Layer warning

Posted: Fri Dec 21, 2018 7:15 am
by Korni
Yes. Or a Info Window in Ideamaker But no email.

Re: Ideamaker: Layer warning

Posted: Fri Dec 21, 2018 7:49 pm
by Vicky@Raise3D
Notes taken.

Re: Ideamaker: Layer warning

Posted: Fri Dec 21, 2018 11:13 pm
by Korni
:D