As subj says. I have retraction tuned up decently, however at start points after longer travels I cannot get rid of blobs. Looks like plastic in 0.8 nozzle after being retracted still floats down a bit. Then after nozzle reaching the distant solid it starts with excessive pressure.
Print Shells in Optimal Order
Tried, makes no difference, nozzle always starts at outer skin shell.
Shell and Infill Order / Infill > Outer > Inner
No difference, as 2 walls are considered as a single "outer shell".
Am I missing something? Cos otherwise this would be quite useful.
Thank you.
