Here are part of the sucessuful prints shared by our Raisers!
Removal of Polysupport
"Everything, but the yellow base to my articulating arm, was printed on my N2. This rainbow of parts was made from (starting at the bottom) Zortrax ULTRAT (green) @260C), Raise 3D PLA Yellow and Red parts @ default 215C, Octave PLA (black) at 220C. The black Octave and the second yellow component from the bottom were printed using PolySupport for raft and support (215C for Raise 3D PLA and 220C for Octave PLA, PolySuppot 240C (using the RT nozzle) @240C."
Kwan Sheung Fung
De Staercke Jos
Byung Hoon Koh
Show off your prints, mods, etc.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest