These pictures do no justice to the actual prints. The lighting is poor in some and in others the flash highlights things not normally seen.
All of these are using the Standard V2 Hotend PLA setting. Changes to this setting are noted in ().
Any and all questions welcome.
Hatchbox PLA - (3 shells, 20% infill, no raft)
Hatchbox PLA - Standard V2 Hotend Setting (3 shells, 20% infill, raft)
Raise3d Premium PLA - (3 shells, 20% infill, no raft)
Very first print. Came out great.
The overhangs on this PLA are a little "stair-steppy" and rough. Sorry R3D, I think the Hatchbox works a little better as shown in green above.
This one I left the doors and lid on by accident and you can see where it started having issues. Withing a few seconds of venting the machine it corrected nicely as you can see in the rest of the print.
Show off your prints, mods, etc.
3 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests