Page 1 of 1

Eiffel Tower - N2 Plus

Posted: Tue May 03, 2016 8:26 pm
by Wibb
Printed using V2 nozzle, v2 heatbed.
Esun ABS, T=265c, Std speeds and feeds, Z step = 0.3, Retract=2.0, Z hop=0.3
Support - external only, support fill = 15%

Time Taken 113h
I had a power blackout at 70h for 2h in the early morning, it recovered without issue :D

IMG_4697.JPG
IMG_4693.JPG

Re: Eiffel Tower - N2 Plus

Posted: Tue May 03, 2016 8:28 pm
by Trhuster
Holy shit, 102 hours and a power blackout. Very very impressive! :)

Re: Eiffel Tower - N2 Plus

Posted: Tue May 03, 2016 8:49 pm
by Charles
Very nice, what was the bed temp?

Re: Eiffel Tower - N2 Plus

Posted: Wed May 04, 2016 5:49 pm
by walshlg
Thanks for before and after cleanup

Did you print with it open or closed?

Re: Eiffel Tower - N2 Plus

Posted: Wed May 04, 2016 7:04 pm
by Andy Cohen
Wow! Nice!

Re: Eiffel Tower - N2 Plus

Posted: Wed May 04, 2016 9:20 pm
by Wibb
110c bed temp, top cover on. downward cooling deleted. peak camber temps 40c, averaged about 37c

Re: Eiffel Tower - N2 Plus

Posted: Thu May 05, 2016 1:13 am
by Julia Truchsess
Bravo!

Re: Eiffel Tower - N2 Plus

Posted: Thu May 05, 2016 2:08 am
by walshlg
I think you just set the bar, lol

Re: Eiffel Tower - N2 Plus

Posted: Thu May 12, 2016 4:39 am
by kdpainter
Wow! How much filament did that take?

Re: Eiffel Tower - N2 Plus

Posted: Sat May 14, 2016 8:07 pm
by Wibb
1100g. the tower itself weighs about 660g
More photos

Re: Eiffel Tower - N2 Plus

Posted: Wed Mar 01, 2017 2:39 am
by Redron357
was this printed in one solid tower..

Re: Eiffel Tower - N2 Plus

Posted: Wed Mar 01, 2017 5:30 am
by Jetguy
Read the first post, Yes, it was printed as a single print that took 113 and during that time, power was lost and the power loss save position recover resumed the print. But again, yes, printed as one piece.

Re: Eiffel Tower - N2 Plus

Posted: Sun Mar 05, 2017 10:50 pm
by redUFO
Amazing how it printed out the rails all the details of the steel without seeing stringing of material everywhere. I've seen this printer do stuff that should have been impossible.

Re: Eiffel Tower - N2 Plus

Posted: Mon Mar 06, 2017 10:19 pm
by Redron357
Could you share the link for the Stl file

Re: Eiffel Tower - N2 Plus

Posted: Tue Mar 07, 2017 8:32 am
by woofy
Don't know which one this but there's a whole bunch of them on thingiverse.
http://www.thingiverse.com/search/page:1?q=eiffel&sa=

Re: Eiffel Tower - N2 Plus

Posted: Tue Mar 07, 2017 8:11 pm
by bellatrixzen
Very Nice Work!!!!!!