I printed this on my Pro2, with the speed setting. It is approximately 9 inches from base of skull to snout, and was derived from a scan, I made using photogrammetry. The horns were sculpted in Zbrush.
The print was post processed with Smooth-On XTC epoxy, mixed with Quarry Tone powder, and finished with an enamel wash and satin/matting spray.
It's been a learning process, for sure.
Show off your prints, mods, etc.
3 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest