1/2 Scale Cow Skull

Show off your prints, mods, etc.
User avatar
red
Posts: 75
Joined: Tue Jan 22, 2019 7:57 pm

1/2 Scale Cow Skull

Postby red » Fri Feb 22, 2019 9:34 pm

I printed this on my Pro2, with the speed setting. It is approximately 9 inches from base of skull to snout, and was derived from a scan, I made using photogrammetry. The horns were sculpted in Zbrush.

The print was post processed with Smooth-On XTC epoxy, mixed with Quarry Tone powder, and finished with an enamel wash and satin/matting spray.

It's been a learning process, for sure.

SkullSideMossSmall.jpg

skullTree.jpg

skullWindow.jpg

cowSkullPrinted.jpg

User avatar
Jay_Omega
Posts: 17
Joined: Wed Dec 26, 2018 2:37 am

Re: 1/2 Scale Cow Skull

Postby Jay_Omega » Sun Feb 24, 2019 1:30 am

That's pretty cool.

What program did you use for the photogrammetry?

User avatar
red
Posts: 75
Joined: Tue Jan 22, 2019 7:57 pm

Re: 1/2 Scale Cow Skull

Postby red » Mon Feb 25, 2019 11:51 pm

Jay_Omega wrote:That's pretty cool.

What program did you use for the photogrammetry?



Thank you, Jay. I appreciate that. I used Agisoft Photoscan.


Return to “User's Gallery”

Who is online

Users browsing this forum: No registered users and 2 guests