Look at this!

Show off your prints, mods, etc.
JGuzman
Posts: 2
Joined: Tue Jan 22, 2019 2:23 pm

Look at this!

Postby JGuzman » Tue Jan 22, 2019 2:30 pm

Has anyone seen a failure this bad? PVA raft and supports with PETG filament. Set to be a 49 hour print but this was just overnight. The last layer of the raft quit before it was complete then the PETG found its way ALL around the heads. :roll: :lol: :roll:
Attachments
20190122_072716.jpg
20190122_072725.jpg
20190122_072756.jpg
20190122_072806.jpg
20190122_072824.jpg

User avatar
Korni
Posts: 284
Joined: Wed Apr 11, 2018 8:11 am

Re: Look at this!

Postby Korni » Wed Jan 23, 2019 6:40 am

:o :(
Pro2+ Image

Shelton
Posts: 375
Joined: Thu Jul 12, 2018 8:34 pm

Re: Look at this!

Postby Shelton » Wed Jan 23, 2019 8:35 pm

I know this feeling very well:
https://www.youtube.com/watch?v=0ITE17EQQbA

Bad support. You should have a big connection area between both materials. Or use PVA only for dense...

crimsonyoshi
Posts: 103
Joined: Mon Sep 24, 2018 6:17 pm
Location: Manitoba, Canada

Re: Look at this!

Postby crimsonyoshi » Fri Jan 25, 2019 8:46 pm

That was me with Hatchbox PLA a few months ago, plus a 7" volcano under the nozzle.

User avatar
sgeolog
Posts: 110
Joined: Wed Apr 20, 2016 2:40 pm
Location: New York
Contact:

Re: Look at this!

Postby sgeolog » Tue Apr 30, 2019 12:48 pm

Hi, How did you clean it? I have almost the same problem with different printer
Attachments
01.jpg

Sunshine
Posts: 32
Joined: Mon Nov 26, 2018 12:53 pm

Re: Look at this!

Postby Sunshine » Sat May 11, 2019 8:30 pm

I had a similar clog on my ultimaker 2+. Depending on the filament, heat the hot ends between Tg and Tm and it should be soft enough to come off with some help.


Return to “User's Gallery”

Who is online

Users browsing this forum: jetdillo and 1 guest