This is a replacement fixture for a light on the exterior walkway of a boat.
The previously one broke after a number of years of exposure to sunlight and weather.
A family member asked me if I could print out a new one vs. going out and buying a replacement(which means you automatically add an extra 0 or two to the price regardless of what the part actually is).
They mailed me the broken parts to model against. I initially tried to scan it in, but once the clean-up started to become a major project in and of itself, I abandoned that approach in favor of just taking pictures and drawing a sketch over top of those.
This was my first serious project in onShape.
Pics show the light installed in a test version of the model for a fit/finish check and the original broken piece off to the side. The test piece was printed in PLA but the final functional replacement will be done in Mat-X ASA.
Hatchbox white PLA
Nozzle temp: 195C
Bed temp: 65C
0.15 layers w/ 4mm nozzle at 60% infill.
Support: Pillar mode, linear fill at 20% w/ 3 layers dense support at 80%.
Show off your prints, mods, etc.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests