Page 1 of 1

Cellular Lamp

Posted: Sun Oct 09, 2016 11:26 am
by Wibb
original file http://www.thingiverse.com/thing:19104
Scale to fit N2+ @ 305x305x605mm
Time to print: 53.5h
Material: ABS (Esun)
Nozzle 0.5mm
Layer 0.4mm
Shells:2
Fill:15% Grid
Travel: 200mm/s
Feed: 70mm/s (all modes)
Bed Temp: 110c
Nozzle Temp:260c
Retract: 2mm
Zhop: 0.3mm
Raft:yes
Support:no

Re: Cellular Lamp

Posted: Sun Oct 09, 2016 1:14 pm
by Rockman
Good job !
Been thinking about printing a similar lamp on my N2 :)

Why did you choose ABS and a 0.5 nozzle ?

Re: Cellular Lamp

Posted: Sun Oct 09, 2016 1:30 pm
by Wibb
0.5 is more robust agaisnt clogging than 0.4, can extrude faster and at taller layer heights. ABS because thats what i have a lot of at this time.

Re: Cellular Lamp

Posted: Mon Oct 10, 2016 6:35 am
by Vicky@Raise3D
That is very eye appealing!

Re: Cellular Lamp

Posted: Mon Oct 10, 2016 5:38 pm
by walshlg
nifty, what will you do to make it a lamp?? please post a final pic