Show off your prints, mods, etc.
1 post • Page 1 of 1
Good morning, I purchased the Raise3D pro, and after having set up ideamaker with the filter and machine profiles, I printed a copy object which I attach below. the walls came out well, but there are some bulges and growths at the beginning, I think, of the nozzle path. Could you help me set up the slicing profile? The filament I use is PETG 225 degrees, 70 print bed, and 60mm/min speed. Thank you all
Who is online
Users browsing this forum: No registered users and 1 guest