Topics around mechanical design, controller and electronics. Mods & hacks welcome.
5 posts • Page 1 of 1
I just got my new Pro2 and noticed that the filament guide tubes are really scratching up the plastic cover. Not a big deal, but it makes the printer look cheap and messy.. Are there any remedies (other than not putting on the cover)??
I really like to be able to have the cover all the way closed, so building on your suggestion: gluing a frame together and place it below the cover may do the trick.. My first plan is to wrap some very soft material around the tubes first to see if that helps..
Who is online
Users browsing this forum: No registered users and 2 guests