Hmm, just a note. I am having trouble confirming which orientation the connector should be attached.
Figure 7 and Figure 8 on the install document do not appear to be consistent with each other. And the silkscreen on my board is not consistent with what the install document seems to tell me to do.
The install document appears to clearly illustrate that PIN 1 (red wire) is UP (top of connector) on the board.
- Figure 1 (before installation) shows the red wire of the ribbon cable at the TOP position.
- Figure 8 (after installation) also shows the red wire in the TOP position.
- Figure 7 shows a connector and shroud that would end up with red wire DOWN if put together (because the connector and shroud are polarized)
- My board has silkscreen markings that indicate red wire should be DOWN.
Here's Figure 7. Shroud on board has keying slot on the left, connector has keying tab on the top surface as pictured. When installed in the only way these can fit together, the red wire on the cable would be towards the BOTTOM.
But pin 1 (red wire) of the connector is shown as being on the TOP in the next photo (Figure 8) -- red arrow added by me.
According to the install doc, this is what it looks like after installation. But the hardware in figure 7 could not go together this way unless forced.
Now if I look at my own board, there is no shroud on the connector. But the silkscreen clearly indicates a key (hard to see in photo but it is on the left) as well as a "pin 1 arrow" at the bottom.
Pin 1 is clearly marked as BOTTOM side on my board, which means red wire mounted on the same side (down).
But the install document seems to clearly show pin 1 (red wire) should be UP.
It also seems inconsistent within the install document given the differences between Figured 7 and 8 which I mentioned above.
So should I install red wire UP (meaning the silkscreen on the board is wrong?)
Or should I install red wire DOWN (meaning the install document pictures are wrong?)