Lower platform using touchscreen
Lower platform using touchscreen
I'm unblocking a nozzle (for the second time today, having had no issues in AGES!) and want to lower the platform for easier access. I'm aware I can do this under Utilities by tapping the down arrow for Z, but it's in 1mm increments so takes ages. Can I modify the value and do it with one tap? E.g. 100mm and then tap down?
Re: Lower platform using touchscreen
factor 10mm is the largest increment you have there
Re: Lower platform using touchscreen
How do you change it to 10mm?
Re: Lower platform using touchscreen
Hit the button on the display in Utilitiy ?
There are several options, step, 0-1, 1, 10, maybe more, just above the x-y and z area of the touchscreen
There are several options, step, 0-1, 1, 10, maybe more, just above the x-y and z area of the touchscreen
Re: Lower platform using touchscreen
Picture tells 1k words.
Re: Lower platform using touchscreen
Be ware that there is no stop at the bottom. Press to much and the bed will bottom out. Sounds (and probably is) really bad.
Re: Lower platform using touchscreen
Ah, got it. I looked at the interface and not really paying attention to the numbers on the left or right (I was a bit annoyed at the blockages at the time and only interested in Z height) thought the central one related to Z and the others related to the icons below.
Should have had a cuppa and come back to it with a clear head!
Should have had a cuppa and come back to it with a clear head!
Who is online
Users browsing this forum: No registered users and 2 guests