PID tune bed

Topics around mechanical design, controller and electronics. Mods & hacks welcome.
Post Reply
3dlabs
Posts: 17
Joined: Sun Dec 17, 2017 6:10 pm

PID tune bed

Postby 3dlabs » Wed Feb 07, 2018 9:28 pm

My bed temp seems to fluctuate +/- 1 degree and is causing some noticeable effect in my prints.

What's the best way to run a PID tune on the bed? The menu only allows for the hotend.
Squenz
Posts: 141
Joined: Fri Dec 01, 2017 11:18 pm
Location: Stuttgart/Germany

Re: PID tune bed

Postby Squenz » Wed Feb 07, 2018 9:29 pm

Sorry, but the bed has no regulation, it's just bang-bang controled.
Post Reply

Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 2 guests