issue printing new support material (Hydrofill)

Topics around mechanical design, controller and electronics. Mods & hacks welcome.
Posts: 160
Joined: Sun Jul 16, 2017 12:00 pm

issue printing new support material (Hydrofill)

Postby Jab136 » Thu Jan 04, 2018 10:31 am

I have had the same issue twice now where the filament was completely cut by the feed gear during printing, I can't tell if it is a clog or something else (this filament does seem to burn very easily) but I have tried several different temperature settings and I can't find anything that works.

Edit: I am currently cleaning burnt material out of the nozzle, so it probably was related to a clog, but I had the nozzle set to 0 degrees whenever it wasn't printing, so I can't think of any other solutions to the issue...

Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 2 guests