Difference between Pro2 and E2

Topics around mechanical design, controller and electronics. Mods & hacks welcome.
freihype
Posts: 1
Joined: Tue Feb 09, 2021 12:51 am

Difference between Pro2 and E2

Postby freihype » Tue Feb 09, 2021 12:57 am

Hello!
I hope this is the right place for this question.

We are planning to buy a new 3D printer for use at work (product design, mostly smaller parts below 10x10x10 cm).
Raise 3D printers seem to be a good choice available here in Japan, so we narrowed it down to the Pro2 and E2.
Until now we have been using a Zortax M200.

Now I am wondering what would be the benefits of the Pro2 over the E2 except for the larger build area?

Looking at the specs they seem quite similar, except for auto bed levelling and the independent extruder of the E2.

But there is a significant price difference over here, so I was wondering if there is anything the Pro2 can do better than the E2?

Best regards

Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 3 guests