Page 1 of 1

Dyze Tungsten Carbide Nozzle

Posted: Thu Apr 16, 2020 5:29 am
by jdaved402
Does anyone know if the dyze tungsten carbide nozzles will work for the Pro2? I believe the thread is the same, but I was wondering if the lengths of the tip are the same as well, or if the z leveling would have to be adjusted for a longer nozzle?

Re: Dyze Tungsten Carbide Nozzle

Posted: Thu Apr 16, 2020 9:03 pm
by jdaved402
Vicky, care to chime in? I have calipers and can take the extruder apart to find these dimensions out myself. All I am hoping for is to save myself the trouble of dismantling portions of the printer unnecessarily. The dyze website has a threaded section length of 7mm and an overall length of 12.5mm, a thread of M6x1.00. Do these dimensions match the nozzle of the Pro2?

Re: Dyze Tungsten Carbide Nozzle

Posted: Fri Apr 17, 2020 11:30 pm
by Vicky@Raise3D
The length needs at least be longer tan 4.5mm. But due to different design and tolerance of different brands, it's hard to gaurantee which 3rd nozzle can work with our hotend seamlessly.

Re: Dyze Tungsten Carbide Nozzle

Posted: Thu May 07, 2020 9:21 pm
by jdaved402
I recently purchased the hardened nozzles from the Raise3d website. In case anyone is wondering, for future reference and so they don't have to dismantle their printers to find this information out: 7.97mm across flat, about 5.55mm length from the top of the flat to the top of the thread, 14mm overall length.