Originally posted by duplicat
On the glass,, not the Buildtak,, and outside of the bot.
Lightly mist,, allow to dry(or use hairdryer),, (lightly mist 3-4times)
Now your plate is “seasoned”. Prior to printing,, lightly mist,, and preheat bed,, allowing hairspray to “surface-dry”,, but not be totally hardened (like from setting around for several hours).
-AQ Superhold , good for PLA
-AQ EXTRA Superhold, is a lot thicker, and is somewhat effective for use with PETG, and small ABS prints.
When print is finished,, place the plate in the freezer for 2 minutes,, and the print will almost fall-off.
Remove residual AQ from bottom of print, with a sponge and hot water.(while upright,, don't want to get water in to the print accidentally)
Topics around mechanical design, controller and electronics. Mods & hacks welcome.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest