What are the thoughts and experiences with upgrading to or using a dual extruder machine vs an adaptor to utilize two or more filaments?
I've seen the Mosaic Palette for a while, and other similar products, but just recently found for the Ender 3 a dual filament mother board and 2nd step motor kit which is a bit more reasonably priced. It's my roommate's Ender 3, but I have the pleasure of utilizing it as well and we have both discussed the possibility of dual filament some. I'd love to hear the general thoughts and consensus!
Palette: https://www.matterhackers.com/store/l/m ... UGEALw_wcB
Dual Extruder Board: https://www.th3dstudio.com/product/crea ... ade-board/
Topics around mechanical design, controller and electronics. Mods & hacks welcome.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests