Has anyone done a 32bit upgrade to the N2 series?

Topics around mechanical design, controller and electronics. Mods & hacks welcome.
User avatar
JohnSays
Posts: 694
Joined: Tue Apr 26, 2016 2:42 pm
Location: Saint Petersburg, FL

Has anyone done a 32bit upgrade to the N2 series?

Postby JohnSays » Fri Aug 23, 2019 8:47 pm

Since my LCD is bad and my speed in printing seems to be limited to the 8-bit motion board, I'm thinking it may be about time to scrap the R3D electronics and go 32-bit. There are now some very inexpensive 32-bit boards. Has anyone else thought about this or, better yet, done it?
- John

2 Raise3D N2 Duals, Bondtech BMGs, adjustable table, Panucatt SD2224 drivers, run-out sensor, thermal overload protection, Firmware 1.1.9ABH - with Lin_Advance, Palette 2 Pro, Custom E3D hot end and ultra-light carriage and printer head

Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 1 guest