KevinOConnor/klipper Firmware

Topics around mechanical design, controller and electronics. Mods & hacks welcome.
FreedomRules
Posts: 60
Joined: Thu Jan 25, 2018 4:34 pm

KevinOConnor/klipper Firmware

Postby FreedomRules » Thu Aug 01, 2019 2:57 am

Has anyone flashed this firmware onto a Raise3d printer? If so whats your thoughts...

EldRick
Posts: 380
Joined: Thu Jun 22, 2017 5:55 am

Re: KevinOConnor/klipper Firmware

Postby EldRick » Sun Aug 04, 2019 4:55 pm

It would appear that no-one knows what you are referring to.

FreedomRules
Posts: 60
Joined: Thu Jan 25, 2018 4:34 pm

Re: KevinOConnor/klipper Firmware

Postby FreedomRules » Sun Aug 04, 2019 10:03 pm

It would appear your right. I guess instead of wasting my time trying to get it to work with Raise3D hardware. I'll just buy a Duet2 board and hook it up and then use it with the Klipper firmware. Basically your 3D printers board just handles the movements. All the calculations are done on another machine running a Klipper master that then sends a stream of movements to the board. Allows for more advanced calculations as most 8 bit controllers take shortcuts on the calculations due to lack of process power for advanced calculations.


Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 2 guests