Wondering where did this fallen part come from?

Topics around mechanical design, controller and electronics. Mods & hacks welcome.
zwang14
Posts: 10
Joined: Wed May 30, 2018 4:37 am

Wondering where did this fallen part come from?

Postby zwang14 » Thu Jan 24, 2019 7:44 am

I found this part at the bottom of my 3D printer. If someone could tell me where did this part fall from? Thanks~
Attachments
Screen Shot 2019-01-23 at 11.43.17 PM.png

User avatar
Vicky@Raise3D
Posts: 5056
Joined: Fri Mar 25, 2016 3:54 am

Re: Wondering where did this fallen part come from?

Postby Vicky@Raise3D » Thu Jan 24, 2019 8:28 pm

One of your endstop switches. There are one at the left rear corner behind the sliding block. Two left front corner, one above the Z height adjusting screw, the other behind the sliding block.
You can check what it looks like from the following page.
https://www.raise3d.com/collections/n-s ... stop-board

amigaman
Posts: 14
Joined: Thu Dec 14, 2017 4:38 am

Re: Wondering where did this fallen part come from?

Postby amigaman » Thu Apr 18, 2019 8:30 pm

THose broke on me all the time until i bought a beefier switch and made my own.


Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 2 guests