My two print heads

Topics around mechanical design, controller and electronics. Mods & hacks welcome.
Posts: 1
Joined: Thu Sep 27, 2018 2:03 am

My two print heads

Postby vincitydaimo » Thu Sep 27, 2018 2:05 am

My two print heads were almost perfectly aligned when it came from the factory. After I swapped both out for V2, I noticed that they are off 1mm'ish on both x and y. I see that there is a setting for x/y offset in IM, so this can be fixed.

However, did anyone noticed this after swapping in the V2 print heads? Were you able to fix it physically on the printer?

I don't see a way to align them physically on the printer

User avatar
Posts: 5285
Joined: Fri Mar 25, 2016 3:54 am

Re: My two print heads

Postby Vicky@Raise3D » Thu Sep 27, 2018 7:12 pm

We recommend to calibrate the X Y offset and nozzle height offset every time after doing some adjustment of the nozzle and hotend.

Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 2 guests