XY rods makes noises (at the center of the buildplate)

Topics around mechanical design, controller and electronics. Mods & hacks welcome.
User avatar
Vicky@Raise3D
Posts: 6925
Joined: Fri Mar 25, 2016 3:54 am

Re: XY rods makes noises (at the center of the buildplate)

Postby Vicky@Raise3D » Fri Jan 06, 2017 10:39 am

Chrigi78 wrote:Dear Vicky@Raise3D

if you check the Video you can see the steel wave have a exenter and is not in line
if you check the Video you can see on second bearing block he move up and down and left and right

so final question can we order no steal wave for a N2 Printer ?


This is also a test step in our factory. It is a QC entry for assembling.
QC will check every printer whether the the sliding block obvious jumping.

Chrigi78
Posts: 20
Joined: Wed Jul 27, 2016 9:14 am

Re: XY rods makes noises (at the center of the buildplate)

Postby Chrigi78 » Fri Jan 06, 2017 12:54 pm

Hey Vicky@Raise3D

ok bad now you can see this is not working and the castoumer absolut not happy
what we can do we order new wave and change

so bakc to the main question can we order alle wave from a N2 Printer yes or no ?

User avatar
Vicky@Raise3D
Posts: 6925
Joined: Fri Mar 25, 2016 3:54 am

Re: XY rods makes noises (at the center of the buildplate)

Postby Vicky@Raise3D » Sat Jan 07, 2017 5:07 pm

We can promise every printer shipped out from our factory has no obvious jumping of sliding block.
And for any problem influences printing, we will provide not only technical support from our resellers and us but also warranty parts replacement.
We will take responsibility for every Raise3D printer.


Return to “Hardware”

Who is online

Users browsing this forum: No registered users and 2 guests