What to calibrate after hotend change on the pro3

[Eric1960]

When changing the hotend on the new Pro3, what do I need to do due too calibration ??

[Ryan@Raise3D]

Once you swap the hot-end out you can click the gear icon in the top right corner and then click maintainece and re-run the offset calibration for the left hot end and the XY offsets for the printer as well.

[Eric1960]

Tx Ryan helps a lot. I need to insert filament as well. Can this only be PLA ?? I don’t use PLA, in case of I need to stock some PLA for calibration

[Steven@Raise3D]

Tx Ryan helps a lot. I need to insert filament as well. Can this only be PLA ?? I don’t use PLA, in case of I need to stock some PLA for calibration

Yes, at this time we only advise running the offset calibration menus with Raise3D Premium PLA.

[Eric1960]

Steven thanks it’s clear to have some stock PLA just for calibration. In your reaction “at this time…..” gives me hope in near future it no longer needed and I can adjust filament and bed temps before calibration.

[Ryan@Raise3D]

The suggestion to allow the calibration prints to use a different temperature has been sent over to our development team.