Page 1 of 1

Ideamaker bridging and brim/skirt adjustments?

Posted: Sun Jun 17, 2018 11:35 pm
by GlowingEmbers
Hi

I have two questions on the Ideamaker software:

Does bridging usually include shells?
Also, is there a way to customize the gap on brims? I'm trying to adjust the brim gap so it can provide adhesion without being too stuck to the print. There is no config for brims and it seems skirts have a 1mm minimum,

Re: Ideamaker bridging and brim/skirt adjustments?

Posted: Tue Jun 19, 2018 2:09 am
by Vicky@Raise3D
1. Bridge bridging settings are applied to solid fill sections only.
2. If you want to have gap between extra bed adhesive structure and model, you'd better use Skirt.

Re: Ideamaker bridging and brim/skirt adjustments?

Posted: Tue Sep 03, 2019 3:09 pm
by Felix_M
Vicky@Raise3D wrote:1. Bridge bridging settings are applied to solid fill sections only.
2. If you want to have gap between extra bed adhesive structure and model, you'd better use Skirt.


Is there an option to do bridging on shells too? This would be a nice feature!

Re: Ideamaker bridging and brim/skirt adjustments?

Posted: Wed Sep 04, 2019 12:32 am
by Vicky@Raise3D
It is a feature we have already developed. You will see it next release.