New version of ideaMaker and Firmware

Discussions about ideaMaker and other printing software.
LonV
Posts: 38
Joined: Mon Mar 21, 2016 8:55 pm

New version of ideaMaker and Firmware

Postby LonV » Wed Mar 30, 2016 4:11 pm

Just got everything installed. Loving the things I've seen so far! Good job, Raise!

LonV
Posts: 38
Joined: Mon Mar 21, 2016 8:55 pm

Re: New version of ideaMaker and Firmware

Postby LonV » Wed Mar 30, 2016 4:16 pm

Warning to those installing, my custom slicing settings were lost.

treisner
Posts: 22
Joined: Mon Mar 21, 2016 1:55 pm

Re: New version of ideaMaker and Firmware

Postby treisner » Wed Mar 30, 2016 4:33 pm

I have custom settings saved as different templates and I still have all of those. The new version reset the three default templates which I had changed to no raft, so I does overwrite the default templates.

LonV
Posts: 38
Joined: Mon Mar 21, 2016 8:55 pm

Re: New version of ideaMaker and Firmware

Postby LonV » Wed Mar 30, 2016 4:49 pm

Huh, weird...my non-default template disappeared. I may be special. :P

User avatar
John@Raise3D
Posts: 483
Joined: Fri Feb 26, 2016 8:42 am

Re: New version of ideaMaker and Firmware

Postby John@Raise3D » Thu Mar 31, 2016 12:51 am

You can edit based on default template and click 'save as' to save it to a new name.

User avatar
dhylands
Posts: 119
Joined: Mon Mar 21, 2016 9:11 pm

Re: New version of ideaMaker and Firmware

Postby dhylands » Thu Mar 31, 2016 5:58 am

Sweet - Linux version!

Andy Cohen
Posts: 170
Joined: Mon Mar 21, 2016 4:43 pm

Re: New version of ideaMaker and Firmware

Postby Andy Cohen » Fri Apr 01, 2016 5:44 am

I noted that in the release notes there was an item about IM using the objects XYZ position. Did I read that correct? If so then the XYZ spot that the object or part is within my CAD or design SW... the same spot that the object appears in NetFab as well... should also show in IM. I do not see that. It's this info that makes it possible to use IM for all dual extrusion scenarios and not just those where both files have the same Z height.

User avatar
John@Raise3D
Posts: 483
Joined: Fri Feb 26, 2016 8:42 am

Re: New version of ideaMaker and Firmware

Postby John@Raise3D » Fri Apr 01, 2016 6:19 am

Andy Cohen wrote:I noted that in the release notes there was an item about IM using the objects XYZ position. Did I read that correct? If so then the XYZ spot that the object or part is within my CAD or design SW... the same spot that the object appears in NetFab as well... should also show in IM. I do not see that. It's this info that makes it possible to use IM for all dual extrusion scenarios and not just those where both files have the same Z height.


No sure which note you are referring to. Currently, IM still does not support changing z height.


Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests