Something missing after slicing!

[anthrax08]

Hy @all,

what i'm doing wrong in the settings? After slicing there is the half balkony missing?
I use the newest Beta.

[zemlin]

My guess is that the features are too small.

[Michael.P@Raise3D]

I would be inclined to agree with zemlin on this one. We have printed the Eiffel tower before and it was full bed volume (larger than your current setup) and the posts were quite small even then.

[zemlin]

You might need to try a smaller nozzle to get those to print. That, of course, will extend the build time.

[anthrax08]

Thanks for your answer.
If this is the problem, it would be nice to get a message from the slicer.

I found this 'Mistake' after printing and it was a bit "not so funny"

[Michael.P@Raise3D]

I can understand that feeling! We get it every once-in-a-while.