Discussions about ideaMaker and other printing software.
2 posts • Page 1 of 1
Hello. This is my first community joining in my life. I hope I'm right here. I've recently had a problem with my pro2. When starting to print, the printer does not start printing in the middle. the x-axis is 12.5mm and the y-axis is 16mm away from the center of the print bed. you would be very grateful for advice.
For the pro2 and the Pro3 the print area shown in the ideamaker software is the actual print area the printer can print in, but on the printer itself this is a bit shifted left and towards the front as there is a bit of space near the back and the right side of the printer that the print head cannot reach. This is normal for the machine and this does not affect the advertised print volume.
Who is online
Users browsing this forum: No registered users and 3 guests