When I print PLA with PVA+, the right extruder clogs after 4-5 layers. I use the Raise PVA+ template.
Extruder temperature on the right is set to 220°C. The extruder pause temperature is set to 180°C . Is the pause temperature too high or too low?
Discussions about ideaMaker and other printing software.
2 posts • Page 1 of 1
The pause temperature of the PVA template is correct at 180 as we need to bring it as low as possible to reduce ooze. Regarding the jamming, can you confirm if the PVA was dried before use as moisture in the filament can start causing jamming.
Who is online
Users browsing this forum: No registered users and 2 guests