First Layer Extrusion ist irregular

Discussions about ideaMaker and other printing software.
maxim_lange
Posts: 1
Joined: Thu Jan 27, 2022 9:48 am

First Layer Extrusion ist irregular

Postby maxim_lange » Thu Jan 27, 2022 10:07 am

Dear community,
I'm just getting startet with the ideaMaker and running constantly into errors...
When I slice my model everything seem correct but when the printer (Vivendo Troodon) starts to print, the First Layer comes out very irregular with massiv overextrusion on the corners (as seen in the foto). I allready testet if the problem is caused by the printer but when I use cura the print is cooming out normal.

You guys have any suggestions?

Maxim :)
Attachments
2022-01-27 11_05_42-ideaMaker 4.2.1 (Vivedino Troodon CoreXY) - _.png
First layer should look like this
2022-01-27 11_04_32-Erweiterte Einstellungen.png
2022-01-27 11_04_51-Erweiterte Einstellungen.png
2022-01-27 11_04_06-Erweiterte Einstellungen.png
IMG_4344[1].JPG
First Lines

User avatar
Ryan@Raise3D
Posts: 412
Joined: Thu Oct 28, 2021 10:43 pm

Re: First Layer Extrusion ist irregular

Postby Ryan@Raise3D » Fri Jan 28, 2022 1:29 am

Can I have you check if your printer uses relative or absolute as this can cause issues with how the printer will extrude material and I would also recommend that you ensure your start Gcode is correct?


Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests