Gcode tab: "Sequential"

Discussions about ideaMaker and other printing software.
User avatar
Pedro Luis
Posts: 32
Joined: Thu May 28, 2020 9:29 pm
Location: Alicante, España

Gcode tab: "Sequential"

Postby Pedro Luis » Thu Nov 25, 2021 6:26 pm

I would like the possibility of executing a certain gcode after "finishing modeling" or at "starting modeling".
For example, my 'End Gcode' ends with:
...
M150 R0 U0 B0; Turn off the led
M107; Turn off fans
M18 X Y Z; Turn off the engines

In sequence printing, after finishing the modeling of a model, the lighting turns off, and it remains off while the remaining models are printing.
So, with a 'Start Sequential Printing gcode', I can set:
M150 R220 U220 B220; Turn on leds

Thanks
Pedro Luis

User avatar
Vicky@Raise3D
Posts: 8240
Joined: Fri Mar 25, 2016 3:54 am

Re: Gcode tab: "Sequential"

Postby Vicky@Raise3D » Tue Nov 30, 2021 2:20 am

Are you looking for inserting GCode while switching from one model from the other just completed printing one during Sequential?
There are a few lines of sequential related codes while nozzle switch. Please advise before or after which line you are looking for to adding more codes.
Image_20211129180313.png

Eric1960
Posts: 11
Joined: Tue Nov 16, 2021 8:37 pm

Re: Gcode tab: "Sequential"

Postby Eric1960 » Tue Nov 30, 2021 7:45 am

One additional question. At the end of the print job lowering the bed to maxZ so it easy to remove the printed part

User avatar
Vicky@Raise3D
Posts: 8240
Joined: Fri Mar 25, 2016 3:54 am

Re: Gcode tab: "Sequential"

Postby Vicky@Raise3D » Wed Dec 01, 2021 1:49 am

Not sure whether you are using our printer or not, if so you can set it up on touchscreen. https://support.raise3d.com/RaiseTouch/ ... 7-885.html
It is calculated the height according to the max Z value of the model than added extra height to lift instead of going directly to Max Z which takes too much time for most users.


Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests