I would like the possibility of executing a certain gcode after "finishing modeling" or at "starting modeling".
For example, my 'End Gcode' ends with:
M150 R0 U0 B0; Turn off the led
M107; Turn off fans
M18 X Y Z; Turn off the engines
In sequence printing, after finishing the modeling of a model, the lighting turns off, and it remains off while the remaining models are printing.
So, with a 'Start Sequential Printing gcode', I can set:
M150 R220 U220 B220; Turn on leds
Discussions about ideaMaker and other printing software.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest