Discussions about ideaMaker and other printing software.
Posts: 1
Joined: Tue May 26, 2020 12:00 am


Postby hidara » Tue Oct 12, 2021 9:41 am

I'd really appreciate any help with the following.
I want to have specific first layer settings as shown in image below.

  • outer perimeters first so that they'll stick to the brim
  • 25mm/s shells and brims
  • 50mm/s infill

First layer speeds are set at 50mm/s in main settings
I've tried
Start Z = 0 and
End Z = 0.3
along with the settings below.
My per layer settings does not seem to take effect as everything is printed at 50mm/s and inner perimeters are printed first.

Any advice would be appreciated


User avatar
Posts: 8200
Joined: Fri Mar 25, 2016 3:54 am

Re: Per-Layer-Settings

Postby Vicky@Raise3D » Wed Oct 13, 2021 3:53 pm

First Layer printing result can be modified by user's own settings.
There's an option for Brim too as Print Outer Shell Before Inner Shell.
Attached more information below for your reference. ... 5-440.html ... 5-436.html ... 5-982.html

Return to “Software”

Who is online

Users browsing this forum: No registered users and 2 guests