Hello,
I have noticed that there is often a lot of stringing between the support columns.
I think it is due to this option? What do you think? Should be disabled or?
thanks in advance.
Stringing between the support pillars
- Vicky@Raise3D
- Posts: 8746
- Joined: Fri Mar 25, 2016 3:54 am
Re: Stringing between the support pillars
You will need to select Rectilinear as Support fill.
It will depend of the filament type. If it is not causing a lot extra stringing, you can enable Avoid Unnecessary Retraction in Support.
It will depend of the filament type. If it is not causing a lot extra stringing, you can enable Avoid Unnecessary Retraction in Support.
Who is online
Users browsing this forum: No registered users and 2 guests