Hi,
To fix a display I have 4 spacers.
Holes inside spacers begin on layer 3.
Before print, I checked in preview the first layer, I didn't see any issue.
But, after external wall it began to print 4 round parts !
then
Yes in the preview all seems perfect, but on print that another story, this leaves very visible marks, especially because it is the front of my model .
I tried many things to avoid this behavior without success, sadly finally had to slice this model with Cura.
First layer failed
Re: First layer failed
A zoom
And files
And files
- Attachments
-
- FrontCover_ideamaker.data
- (54.04 KiB) Downloaded 97 times
-
- FrontCover.idea
- (951.93 KiB) Downloaded 87 times
-
- FrontCover_ideamaker.gcode
- (2.69 MiB) Downloaded 84 times
- Vicky@Raise3D
- Posts: 8746
- Joined: Fri Mar 25, 2016 3:54 am
Re: First layer failed
You can try 0 bottom surface solid fill layer and top surface solid fill layers.
Re: First layer failed
I tried 1 but not 0 , I will try 0.
Thank you Vicky
Thank you Vicky
Re: First layer failed
There is really something wrong, again this annoying behavior.
Hope a change in the next update.
Have a nice day
Hope a change in the next update.
Have a nice day
- Vicky@Raise3D
- Posts: 8746
- Joined: Fri Mar 25, 2016 3:54 am
Re: First layer failed
Can you share me the values you put for Top surface layers and bottom surface layers?
Re: First layer failed
Vicky@Raise3D wrote:Can you share me the values you put for Top surface layers and bottom surface layers?
Top surface = 2
Bottom surface = 2
So I tried:
Top surface = 1
Bottom surface = 2
Then the behavior only happens from the second layer
Top surface = 0
This workaround works
Thank you Vicky
- Vicky@Raise3D
- Posts: 8746
- Joined: Fri Mar 25, 2016 3:54 am
Re: First layer failed
It seems the Top surface and Bottom surface settings are different. Once it enabled, it will generate two different types of solid infill.
Who is online
Users browsing this forum: No registered users and 2 guests