The printer is not printing to the center of the table.

Discussions about ideaMaker and other printing software.
Pavel
Posts: 3
Joined: Tue Aug 01, 2017 8:41 pm

The printer is not printing to the center of the table.

Postby Pavel » Sun Jun 20, 2021 7:14 pm

Глупый вопрос, но возникла проблема.
При установке модели по центру в слайсера, принтер печатает модель не в центре.
В настройках изменения этого параметра не нашел. Помогите советом.

Silly question, but there was a problem.
When placing a model in the center of the slicer, the printer prints the model off-center.
I did not find this parameter in the settings. Help with advice.

User avatar
Steven@Raise3D
Posts: 399
Joined: Thu Dec 17, 2020 11:24 pm

Re: The printer is not printing to the center of the table.

Postby Steven@Raise3D » Mon Jun 21, 2021 11:37 pm

Pavel wrote:Глупый вопрос, но возникла проблема.
При установке модели по центру в слайсера, принтер печатает модель не в центре.
В настройках изменения этого параметра не нашел. Помогите советом.

Silly question, but there was a problem.
When placing a model in the center of the slicer, the printer prints the model off-center.
I did not find this parameter in the settings. Help with advice.


Due to the machine having dual hotends the build volume is slightly offset to compinsate. The printer profile in ideaMaker has already accounted for this so you shouldn't have any issues with full volume prints.


Return to “Software”

Who is online

Users browsing this forum: No registered users and 3 guests