Page 1 of 1

ideamaker adap. infill

Posted: Fri May 07, 2021 9:18 pm
by 3dandi
hallo,

I try to print a wheel.

howto make adap. infill in horizontal direction?

with me infill work vertical,top only.

my config:
ideamaker 4.1.1
adap.infill:on
count:4
range: 5-30
layers:5
hor expand: 0.30
min width: 3.00

result: adapt. infill on top only.
see pictures

whats going wrong?


regards andy

Re: ideamaker adap. infill

Posted: Mon May 10, 2021 11:41 pm
by Vicky@Raise3D
Would you mind to mark the issues out in the images?