I am printing with wood filament at 165-185c and it is prone to clog/burn if left in the nozzle, so I want it to purge filament and then retract enough to exit the hot zone after it is done printing.
Does this look good? Not sure how far I need to retract, so if anyone else got any hint about how much I should retract then please let me know. I want enough for it to be in the top part of the heat break, but not so much that it unload.
M221 T0 S100
G1 E-1 F300
G1 Z+0.5 E-5 Y-20 F9000.00
G28 X0 (Park the head left)
G1 E20 F200.00 (Purge filament)
G1 E-20 F9000.00 (retract enough to exit hot zone)
G28 Y0 (home Y)
Discussions about ideaMaker and other printing software.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest